Crystal Serum Light - 50ml

review
0
0
5
Your Price: $99.00
Part Number:135
  • Best possible swirl mark and chemical resistance from a prosumer grade product
  • Incredible gloss
  • 3 to 5 years durability

To apply CSL your vehicle must be indoors and it must remain indoors for at least 12 hours after application 
 
Ambient conditions must be above 3 degrees C and below 25 C
Wash and then decontaminate your vehicle’s paintwork with Gtechniq W5 Citrus All Purpose Cleaner and W6 Iron and General Fallout Remover.  If required, clay your paintwork to remove other bonded contaminants
 
If needed, polish your paintwork, either by machine or by hand, to remove any imperfections
 
Spray Gtechniq Panel Wipe onto a microfiber towel
 
With your panel fully cooled after polishing, taking care to avoid any paint protection film or other types of vinyl film, buff away all polish residues.  This process ensures you will get the maximum number of chemical bonds between the coating and your vehicle’s paintwork
 
Put on the gloves provided to prevent CSL coming into contact with your skin
 
Soak the application pad with two full measures from the pipette and work the liquid into the pad to get an even saturation
 
Replace the lid on the bottle and set aside - do not keep the bottle in your hand as this promotes premature curing
 
Apply with applicator provided in overlapping strokes to an area roughly 2’ x 2’, or work to the bodylines of the vehicle 
 
After coating a single small panel or half a larger panel, remove residue with microfiber towel. Always remove from further than you have applied, working from the outside in. It is essential to check for residue 
 
You may need to buff the same area several times to remove residue.  We recommend using two microfiber cloths at any one time.  Please note that you are only removing excess product
 
When working with coatings, we recommend you inspect the panels with a bright but diffuse light source, not with bright spot lights which are very poor for spotting coating residue
 
Avoid buffing with too much force as this can spoil the surface you are protecting, and you may also drag the partially cured coating off the surface
 
Take care that the microfiber cloths you are using are rotated sufficiently and quickly so that CSL does not partially cure in the cloth, if it does cure then buffing residue will be significantly more difficult
 
If you miss removing residue and it cures fully, you should re-polish this area, and reapply CSL
 
As soon as you finish put the microfibers in water, and wash and dry them as soon as possible
 
Use CSL within 1 year of purchasing, for best results, once opened use within 3 months
 
Store opened bottles in a dry and cool storage area that is out of direct sunlight

Related Items